zincate question

Posted by admin on February 2nd, 2009 at 04:00am

Can anyone answer this question i have? I have recently zincated an ally piece followed by acid copper , came out fine but in a couple of tiny areas i can still see the zincated underlayer, around the edges where was no doubt thinner, the question is can i dip the piece back in the zincate or will it ruin the copper finish i have obtained,can these small areas be touched in somehow? Thanks in advance.

This is post is sent to the Surface section from a blog about Aluminium, , Plate, Metals, Nickel, Chemical, Anodising, Chrome , or Chromic acid. Post title is zincate question and blog title is Powder Buffing – Caswell Inc. Metal Forum. Please click. to view the orijinal source.

Related posts:

  1. surface area and amperage calculation question just wondering if anyone uses weigh to calculate amperage. I...
  2. surface area and amperage calculation question just wondering if anyone uses weigh to calculate amperage. I...
  3. surface area and amperage calculation question just wondering if anyone uses weigh to calculate amperage. I...
  4. what happens when you nickel plate aluminium with out zincate? the reason...
  5. Elctro plating copper and aluminum at the same time Hello there, I produce Marine air conditioners. We need a...

Tags: , , , , ,

Under metal finishing

Leave a Comment for zincate question

Required

Required, hidden

Subscribe to the comments via RSS Feed

Recent Blog Posts

Categories

Tags

Posts by Month

Blogroll