Here is a photo of my set up that I’m working on.
It is 14×6x5 ½ deep.
Right now all I need to do is one rifle receiver.
There is only one anodizing company her in St, Louis and they don’t do rifle receivers.
I don’t mind doing it my self (I think its fun).
I have been on other sites and they say all you need is a 12v battery or battery charger to do a good job, and they have photos to show.
I have anodized in the past with just a 12v battery charger.
They where slot car tools that I machined .And they came out looking good.
With the receiver I have close tolerances, so I don’t want to make any mistakes.
After reading here I’m scared of messing up.
Here on this site you all get into more detail, more precise.
I have limited space, so keeping in mind the formula 720 rule and surface area.
Is my tank size going to work for me?
Any help would be great, Rich

Attached Thumbnails