Running very high voltages?
Posted by admin on October 5th, 2009 at 11:26pm
So I’ve always had slightly higher than stated peak voltage than the calculator since I’ve started.
However lately, its been A LOT higher.
I’m doing 72 sq in at CD of 7. Requiring 3.5A, and a peak voltage of about 17.5.
However, its the start of the run and I’m already pushing 25v.
However lately, its been A LOT higher.
I’m doing 72 sq in at CD of 7. Requiring 3.5A, and a peak voltage of about 17.5.
However, its the start of the run and I’m already pushing 25v.
Any ideas? More acid, more water, more dissolved aluminum, etc?
Related posts:
- Problems after change from CV to CC I replaced my CV power supply to a CC power...
- second coating question.. OK, applied first coat (silver base) at 30kv came out...
- Oven Build 4 foot high x 2foot wide x 2 foot deep I need help building and designing this, i dont know...
Under metal finishing
Leave a Comment for Running very high voltages?
Subscribe to the comments via RSS Feed