light spots on my parts
Posted by admin on April 11th, 2010 at 12:08am
ok so i did my first sucesfull ano job.
the only problem i had was on the paintball gun i anodized i used aluminum wires to rack the parts where i bent over the wires and screwed them into the parts i wound up with light spots forming right around where they was connected. what could of caused this fading?
i do not have a good pictue that i can post of this since i did a splash over the jus and bleached out the color from the faded areas. the finished parts overall looks quite well i just need to know if i am doing something wrong as i will nedd to correct this.
the only problem i had was on the paintball gun i anodized i used aluminum wires to rack the parts where i bent over the wires and screwed them into the parts i wound up with light spots forming right around where they was connected. what could of caused this fading?
i do not have a good pictue that i can post of this since i did a splash over the jus and bleached out the color from the faded areas. the finished parts overall looks quite well i just need to know if i am doing something wrong as i will nedd to correct this.
any thought
Thank you;
Carl Jenny
Related posts:
- Avoid parts in direct sun light I was reading this message on some flat black "Avoid...
- Spots not taking dye I have been ano’ing for awhile now but I went...
- Spots not taking dye I have been ano’ing for awhile now but I went...
- Spots not taking dye I have been ano’ing for awhile now but I went...
- polishing curved tight spots-best roduct to use? im going to be polishing an intake manifold what’s a...
Under metal finishing
Leave a Comment for light spots on my parts
Subscribe to the comments via RSS Feed